Peugeot 308 Key Fob Replacement
Peugeot's 308 could be catching on a little however it's still attractive. It's not the most luxurious vehicle in its class, but it is a relaxing and civilised driving experience.
We get asked frequently at Coded Car Keys to replace peugeot key fobs. These tips can aid whether the issue is constant or intermittent.
Water Damage
If you accidentally drop your key fob in a puddle or get it wet while swimming, kayaking, canoeing, rafting or canyoning, it's more likely to suffer water damage. The best way to avoid this from happening is to always keep it in a dry bag whenever you're outside or performing activities in which the fob may be exposed to high levels of water.
You'll also need to ensure that the fob is dry prior to opening it and using it again. If you detect any smells emanating from the fob like an industrial liquid smell or windshield washer fluid, this is another sign that it's been submerged in water.
A wet circuit could cause the battery's charge to be drained or even explode. If you're able to fish your key fob 308 out of whatever body of water it got stuck in turn the button upside down and shake out as much water as you can before opening the case. Remove the battery, then wipe the circuit board down with a cotton swab that has been dipped in 90-percent alcohol.
Other reasons why your Peugeot 308 remote keyless entry system might be unable to function could be due to a dead coin battery or receiver module issue, signal interference, or an electronic chip that is defective. If none of these is the cause, you can try resetting your system by disconnecting the 12 volt battery for approximately 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with remote start which allows drivers to start their car from a distance, allowing them to warm up or cool down the vehicle before they get in. This feature is very useful, especially in the cold winter months. The remote start system can not function due to a variety of reasons, such as an inactive coin-battery.
The coin-shaped battery contained inside the key fob can last between two and four years based on how frequently it is used, the location it was purchased, and the way it is used. The date for use-by is typically printed on the package or listed in the instruction manual.
If the key fob is not functioning after exposure to water that is clean and you want to take the battery off, clean the chip with a paper towel and isopropyl alcohol, then dry it thoroughly before replacing it. In the event of exposure to soapy or salty water, the chip may be fried and you will have to replace the key fob altogether.
If you're not certain the battery is faulty, you can test its voltage with an instrument set to the vehicle's voltage range and connected to the terminals for minus and plus. If the voltage is lower than 12-13 volts you need to replace the battery. You can also reset the onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should now start.
Faulty Receiver Module
If you're not getting the "Key Detected" message on your dashboard, then it's possible the receiver module has created a fault. It's the part that transmits a signal to the car when your key fob is activated which also acts as an immobiliser. It stops it from starting until the correct key is in place.
This could be caused by several factors, including water damage or simply aging. If the electronic chip within your Peugeot 308 keyfob has been damaged by dirty tap water, it could be because the keyfob was exposed it. In this case you will need to remove it and thoroughly clean it with isopropyl or an electronic cleaner. When the battery is clean, you can try again.
If the problem persists it is recommended that you visit an area Peugeot expert or locksmith. They can utilize a diagnostic tool in order to pinpoint the problem and repair it.
The loss of your Peugeot car keys could be an extremely stressful experience. However, a reputable auto locksmith can fix the issue in only a few minutes. They can cut a new key and programme it to your vehicle, so you're back out on the road as quickly as possible. Find a locksmith in your area.
Faulty Electronic Chip
The electronic chip in the Peugeot 308 key fob is a very vital component of the remote control system. If peugeot 206 key replacement G28 gets damaged, your car might not start or you might receive a message saying "anti-theft active". In this case, the only solution is to replace the key. Fortunately, auto locksmiths with experience can provide the service in the shortest amount of time.
The chip in your Peugeot 308's key fob could be damaged due to various reasons, such as sweat, water damage or dirt. If your Peugeot key fob was exposed to dirty or soapy water, it must be cleaned as soon as possible. You can make use of a towel and isopropyl ethanol to clean the electronic component. Then, you need to let the battery dry completely.
Radio interference can cause a key fob's functionality to cease. This could be caused by other devices that operate on the same frequency as your Peugeot key fob. It can also be caused by weather conditions or objects in the vicinity. It is recommended to see a Peugeot dealer in the event of this problem.
The Peugeot 207/308 key fob is very delicate and requires special care. It is not recommended to drop it or throw it around. If you lose it, try to locate it as soon as you can. You can reset the onboard computer by disconnection of the battery for a couple of minutes. Be sure to disconnect the negative first, and then the positive.